If I would want to list the all the devices on Linux, on the subnet 197.577.52.1, I would run sudo nmap -sP 192.577.52. I tried many terminal commands, but it didnt really work. 2 Answers Sorted by: 2 On linux I use nmap ( ), which is also available for Mac according to their website. Is that correct? or do I also need to add the sharename to the end of that? As I did not get any improved results. I want to list all IP addresses with their Computers names (if my IP was 197.577.52.4: 197.577.52.4 - Lucas MacBook) through Mac Terminal or Mac Software. # prevent Apache from glomming onto all bound IP addresses (0.0.0.0) # Change this to Listen on specific IP addresses as shown below to I added my pc’s ip address to the following lines in Apache’s nf: # Listen: Allows you to bind Apache to specific IP addresses and/or So, I can only assume that I will need to tweak Apache (as you mentioned). html” and saved it to that directory and when I browsed to it again, I was able to see index.html rendered correctly. When I browsed to that folder (from the pc, in a browser), I was shown the directory itself (files and folders) but, I created a file, “index. OK, I tested browsing to the directory on my mac (from the pc). In which case, you will need to tweak the apache setup to listen on other addresses. Wwb_99: Unless the mac is not properly configured to accept http connections from outside of localhost, that is. Every website has its own IP address, but you substitute a. The IPv6 loopback address is ::1.You can even find t-shirts that say There’s no place like 127.0.0.1. 9 I need to figure out the local IP address of Github runner, which uses macOS 11. That is the most commonly used IPv4 loopback address and it is reserved for that purpose. Unless the mac is not properly configured to accept http connections from outside of localhost, that is. On almost all networking systems, localhost uses the IP address 127.0.0.1. To find the IP addresses of your router and various devices on your network, you can run arp or ipconfig. Open Terminal and type the following: ifconfig grep 'inet ' grep -v 127.0.0.1. The best way to do this is to explicitly state “Hey, windows, this is a http connection!” by typing in your windows browser. In OS X 10.4, go to the TCP/IP tab to view the IP address. What you need to do is open a http connection. The -n option disables attempting to resolve the IP addresses into domain names, and the -P disables attempting to figure out the name of a particular port. You are connecting to a file share using \\192.168.0.5\ShareName. I use the command below when I want to see everything thats on a specific port for either TCP or UDP. So, basically, I wanted to be able to open up the site to test it from the pc, without always having to upload my modified files to my sites remote server for testing. If I was to browse to those files (.php) across the network from the pc, and tried to open one of them, then it would open them with dreamweaver, or my pc’s default app. On the mac, I have all my files (for Apache localhost) in a folder, and have set up a doc root in nf, so, when on the mac, I open up and it shows me the site that I am testing locally. Hi… yeah, I already have the mac connected across the network, and have used its ip address to establish the connection (192.168.0.5).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |